Human Touch Perfect Chair PC-600 Mode D'emploi Et D'entretien page 7

S
Install the power hub
1. Gently tip the chair forward onto the footrest (Fig.9).
2. Locate the four screw holes on the rear of the front cross bar.
Fig.9
3. Using the provided Phillips-head screwdriver and screws, secure the power hub to the chair with the
power cord facing to the right (Fig.10).
Fig.10
humantouch.com
Front cross bar
Power hub
10
4. Open the canvas pocket on the bottom of the chair, remove the coiled cable, remove the cable tie,
then return the cable to the pocket with the plug positioned at the top (Fig.11).
Remove
cable tie
5. Pull the plug gently out of the pocket, guide the cable through the two cable guides on
the chair canvas, plug it into the left-hand power hub receptacle, then close the canvas pocket using
the hook-and-loop fasteners (Fig.12).
Fig.12
Pocket
Fig.11
Plug in cable
11 11