Human Touch Perfect Chair PC-600 Mode D'emploi Et D'entretien page 13

5. Pull up on the backrest pad until the hook-and-loop fastener strip on the back of the pad aligns with
the hook-and-loop fastener strip on the chair canvas, then press the two strips firmly together (Fig.31).
Hook-and-loop-fastener strips aligned
Backrest pad
Fig.31
6. Tuck the flap on the top of the body pad up into the headrest pad and smooth the lower part of the
headrest pad firmly flat to secure the hook and loop fasteners inside (Fig.32).
Headrest pad
Body pad
Fig.32
humantouch.com
22
7. Plug in the chair, then return it to the upright position.
8. Tip the chair gently forward until it is resting on its headrest.
S
9. Locate the canvas cable guide just to the right of the canvas pocket, then do one of the following:
S
• If the cable guide is vertical, loop the strap on the bottom of the backrest cover through the left-hand
cable guide, twist it so the hook-and-loop fasteners are aligned, then secure it using the hook-and-loop
fasteners (Fig.33).
• If the cable guide is horizontal, insert the end of the strap through the cable guide from the top, pull
it back upward, then attach it to the strap using the hook-and-loop fasteners.
VERTICAL CABLE GUIDE
Hook-and-loop fasteners
Cable guide
HORIZONTAL CABLE GUIDE
Hook-and-loop fasteners
Cable guide
Fig.33
10. Place the neck pillow at the desired height; a magnet
holds it in position (Fig.34).
Back cover
Back cover
Fig.34
23