PEERLESS SP730P Directives D'assemblage Et D'utilisation page 4

Installation to Wood Stud Wall
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
Using a stud finder, locate and mark the edges of the wood stud used in mounting this product. Use of an edge to
1
edge stud finder is highly recommended. Use a level to draw a vertical line down the center of the stud. Use wall
plate as template to mark center of holes along the vertical line. Drill two 5/32" (4 mm) dia. holes 2.5" (65 mm)
deep. Attach wall arm assembly (A) to wall using two #14 x 2.5" flat head wood screws (D) as shown.
Skip to step 2 on page 6.
• Tighten screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the screws,
greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the studs. The use of an "edge to edge" stud finder is
highly recommended.
A
WARNING
WARNING
D
WOOD
STUD
WALL