Before The First Use; Contents Of Packing - Batavia MAXXPACK 18V Mode D'emploi

wood scraps, or for any other reason
while the blade is spinning. The prox-
imity of the spinning saw blade to your
hand may not be obvious and you may
be seriously injured.
g. Inspect your workpiece before cutting.
If the workpiece is bowed or warped,
clamp it with the outside bowed face
toward the fence. Always make certain
that there is no gap between the work-
piece, fence and table along the line of
the cut. Bent or warped workpieces can
twist or shift and may cause binding on
the spinning saw blade while cutting.
There should be no nails or foreign
objects in the workpiece.
h. Do not use the saw until the table is
clear of all tools, wood scraps, etc.
except for the workpiece. Small debris
or loose pieces of wood or other objects
that contact the revolving blade can be
thrown with high speed.
i. Cut only one workpiece at a time.
Stacked multiple workpieces cannot be
adequately clamped or braced and may
bind on the blade or shift during cutting.
j. Ensure that the mitre saw is mounted
or placed on a level, firm work surface
before use. A level and firm work sur-
face reduces the risk of the mitre saw
becoming unstable.
k. Plan your work. Every time you change
the bevel or mitre angle setting, make
sure the adjustable fence is set cor-
rectly to support the workpiece and
will not interfere with the blade or the
guarding system. Without turning the
tool "ON" and with no workpiece on the
table, move the saw blade through a
complete simulated cut to assure there
will be no interference or danger of
cutting the fence.
l. Provide adequate support such as
table extensions, saw horses, etc. for
a workpiece that is wider or longer
than the table top. Workpieces longer
or wider than the mitre saw table can tip
if not securely supported. If the cut-off
piece or workpiece tips, it can lift the
lower guard or be thrown by the spin-
ning blade.
m. Do not use another person as a sub-
stitute for a table extension or as
additional support. Unstable support
for the workpiece can cause the blade
to bind or the workpiece to shift during
the cutting operation pulling you and
the helper into the spinning blade.
n. The cut-off piece must not be jammed
or pressed by any means against the
spinning saw blade. If confined, i.e.
using length stops, the cut-off piece
could get wedged against the blade and
thrown violently.
o. Always use a clamp or a fixture
designed to properly support round
material such as rods or tubing. Rods
have a tendency to roll while being cut,
causing the blade to "bite" and pull the
work with your hand into the blade.
p. Let the blade reach full speed before
contacting the workpiece. This will
reduce the risk of the workpiece being
thrown.
q. If the workpiece or blade becomes
jammed, turn the mitre saw off. Wait
for all moving parts to stop and dis-
connect the plug from the power
source and/or remove the battery
pack. Then work to free the jammed
material. Continued sawing with a
jammed workpiece could cause loss of
control or damage to the mitre saw.
r. After finishing the cut, release the
switch, hold the saw head down and
wait for the blade to stop before
removing the cut-off piece. Reaching
with your hand near the coasting blade
is dangerous.

5. Before the first use

Remove the machine and all accessories
from the package. Keep the packaging
materials out of the reach of small children.
There is a danger of suffocation!

6. Contents of packing

1× Cordless sliding mitre saw
1× Dust collection bag
1× 216mm 48 teeth saw blade (assembled)
2× Sets extension bars
1× Instruction manual
English
11