Fitting The Unit Door - Atag KD8178AFUU/A01 Instructions De Montage

Installation
u By screwing long Spax screws
Fig. 16 (22) through the top and
bottom hinge plates.
On the handle side at the top:
u Loosen the screws
Fig. 17 (19) a little.
u Tightly screw the top
mounting bracket
Fig. 17 (17) to the unit
wall using Spax screw
Fig. 17 (25) ø4x19.
u Break off the projecting
end of the cover
Fig. 17 (16) .
Fig. 17 (19) .
u Tighten the screws
Fig. 17 (16) .
u Put on the cover
On the handle side at the bottom:
u Loosen the screws
Fig. 18 (19) a little.
u Tightly screw the bottom
mounting bracket
Fig. 18 (17) to the unit wall
using Spax screw
Fig. 18 (25) ø4x19.
u Break off the projecting
end of the cover
Fig. 18 (16) . It is no longer
required.
u Tighten the screws
Fig. 18 (19) .
Fig. 18 (23)
u Put the cover
on the bottom mounting
bracket Fig. 18 (17) .
u Close the appliance door.

4.2 Fitting the unit door

u Check 8 mm-presetting. (Distance between appliance door
and lower edge of crosspiece)
u Slide up the assembly aids
unit door. Lower stop edge ▲of the assembly aid = upper
edge of the unit door to be fitted.
u Unscrew the crosspiece
Fig. 19 (32) .
nuts
18
Fig. 19 (30) to the height of the
Fig. 19 (31) by undoing the lock-
u Attach the
Fig. 20 (31)
piece
together with
assembly
Fig. 20 (30) to the
inside of the unit
door.
u Concentrically align
the crosspiece
Fig. 20 (31) : Mark a
short centre line on
the unit door and put
the tip of the arrow
on the crosspiece
Fig. 16
over it.
w Distances to the outer edge are equal at the left and right.
For particle board doors:
u Tightly screw the crosspiece
least 6 screws
For frame and panel doors:
u Tightly screw the crosspiece
Fig. 20 (34) at the edge.
screws
u Raise and remove the assembly aids
and slide them into the adjacent openings.
Fig. 17
u Attach the unit door to the adjusting bolts
loosely screw the locknuts
bolts.
u Close the door.
u Check the gap between the door and the surrounding unit
doors.
u To laterally align the unit door: Move the unit door in the X
Fig. 18
direction.
u To align the unit door in height Y and in lateral inclination:
Adjust the adjusting bolts
w The unit door is flush and in alignment with the surrounding
unit fronts.
u Tighten the lock nuts
Ensure that both metal edges are flush (symbol //):
u Drill pilot holes in the door of the unit (possibly make prelimi-
nary hole with a bradawl).
u Screw the appliance door to the unit door with screws
Fig. 19
Fig. 22 (34) passed through the mounting brackets
Fig. 22 (12) .
cross-
the
aids
Fig. 20 (31) into place using at
Fig. 20 (34) .
Fig. 20 (31) into place using 4
Fig. 20 (30) , turn them
Fig. 21 (32) onto the adjusting
Fig. 21 (33) using a screwdriver.
Fig. 21 (32) .
Fig. 20
Fig. 21
Fig. 21 (33) and
Fig. 22