Demount Door; Change Freezer Compartment Door; Changing Bearing Parts; Re-Fit Door - Atag KD8178AFUU/A01 Instructions De Montage

3.1 Demount door

Fig. 1 (1) .
u Lift off covers
u Only slacken fastening screws
u Remove door: push outwards, unhinge and set aside.

3.2 Change freezer compartment door*

u Fold away cover of turn hinge
Fig. 2 (6) together with compartment
u Unscrew turn hinge
door.
Fig. 2 (7) .
u Unscrew closing element
u Close the vacated holes with the accompanying stoppers
Fig. 2 (8) .
Fig. 3 (7) .
u Fit closing element
u Fit compartment door at the top.
u Fit turn hinge Fig. 3 (6) and fold the cover.

3.3 Changing bearing parts

CAUTION
Risk of injury if hinges fold!
u Leave hinges open.
Fig. 1
Fig. 1 (2) .
Fig. 2
Fig. 2 (6) .
Fig. 3
u Transfer top and bottom
Fig. 1 (2)
fastening screws
to the opposite side.
Screws are self-tapping. Use
cordless screwdriver:
u Unscrew Fig. 4 (9) the
hinges from the door,
transfer them and screw
them on tightly (4 Nm).
u Close vacated fastening
holes with stoppers
Fig. 4 (10) .

3.4 Re-fit door

u Attach appliance door to the prefitted fastening screws
Fig. 1 (2) .
u Screw in mounting screws Fig. 1 (2) tightly (4 Nm).
Fig. 1 (1) .
u Re-fit covers
WARNING
Risk of injury due to the door dropping out!
If the fastening parts are not screwed into place firmly enough,
the door may drop out. This may lead to severe injuries. What
is more, the door may not close and therefore the appliance
may fail to cool properly.
u Screw the hinges firmly into place (with 4 Nm).
u Check all of the screws and retighten if necessary.

4 Installation

All the mounting components accompany the appliance.
Installation
Fig. 4
15