Cleaning The Interior - shark SPARTAN RS Manuel D'utilisation

CLEANING THE INTERIOR

All interior fabric materials are was-
hable; to avoid their deterioration, it
is necessary to strictly adhere to the
following guidelines:
The cheek pads and peak must be
hand-washed in warm soapy water
(at approx. 30°C). Avoid using harsh
detergents, but rather a small dose of
detergent specifically designated for
delicate fabrics or else a very mild soap.
Prior to helmet use, it is essential to
ensure that the fabrics and foams have
completely dried. This drying step must
be carried out at room temperature.
Never iron any of the fabric materials.
For parts with a leather finish or fabrics
bonded to safety components, use a
sponge or slightly dampened cloth with
just a bit of mild soap and then rinse in
clean water.
Avoid using too much water on compo-
nents made of polystyrene.
You must fully ensure that all interior
parts are perfectly dry before using the
helmet.
WARNING! Damaging the inter-
nal foam will alter your actual
helmet size. If no longer adjusted to
fit your head, the helmet may come
off, thus leaving your head exposed
without protection and potentially
8
causing serious, or even fatal, injuries.
THE TEXTILE PARTS
The Spartan RS comfort fabrics and
foams will help you better appreciate
your helmet's performance. The parts
in contact with your skin are made with
a fabric guaranteed to be pleasant to
the touch, in addition to offering a high
level of perspiration absorption and
good resistance to ageing. By relying
on our surface treatment, we have
successfully limited the risks of mould
and bacteria build-up.
WARNING!
rigorously selected for their
strength and durability over time, all
parts of the interior lining are sub-
jected to normal wear, depending on:
the level of care and maintenance,
the time in use, and the acidity pro-
perties of your perspiration. Should
you observe wear-induced ageing, we
advise replacing the interior fabric
and foam in order to extend the
lifetime of a perfectly clean helmet
capable of providing the requisite
level of comfort. Your retailer may
be able to propose replacements and,
as an option, cheek pads of different
thicknesses and densities should the
standard choices not match the mor-
phology of your face.
WARNING! Each time you put
on your helmet, check the fit as
discussed in "Choose your size".
Despite being