shark SPARTAN RS Manuel D'utilisation page 2

WARNINGS and INSTRUCTIONS
1. Always be careful when riding. Even though
this helmet meets or exceeds global standards
applicable to helmet manufacturing, still it cannot
fully protect the user from all possible shocks at
both high and low speeds. Every type of safety
gear has its limitations, and a head injury is indeed
possible in an accident even when a helmet is
being worn. Nonetheless, in order to be protected
from a fatal accident or permanent disability due
to a head injury, the helmet size must absolutely
correspond to the size of your head; moreover,
the chin strap must be adequately tightened, as
indicated in this manual.
2. This helmet has been designed so as to absorb
the impact by the partial destruction of the shell
and/or internal damper. This damage may not in
fact be visible. Consequently, should the helmet
be subjected to an impact, even in the event of
simply being dropped on the ground, it must
be returned for verification, replacement or
disposal, regardless of whether any deterioration
is apparent. In case of doubt and if you're not sure
whether this rule applies to the shock in question,
contact your retailer prior to any subsequent use
of the helmet.
3. Like all products, a helmet can become
deteriorated over time under normal use
conditions. Before each use, be sure to inspect
the helmet for any sign of deterioration or
damage. The helmet size must always correspond
to your head size. If such is no longer the case,
then the helmet has expanded and you'll need to
replace it. Never wear a damaged helmet. Even if
the helmet is not damaged or deteriorated, it is
recommended to buy a new one every five years.
4. No modification is ever to be made to the
helmet. Never drill or cut any helmet component.
Even the slightest modification can degrade the
helmet and, as a result, reduce its protective
capacity in the event of an impact.
5. Handle the helmet with the utmost precaution.
Never sit on it or throw it on the ground. Never
ride with the helmet dangling on any part of
the bike.
6. Never use gasoline, petroleum products,
chemicals or any solvent when cleaning the
helmet, the shell or the visor. Moreover, never
expose your helmet to the vapours of these
solvents (e.g. by leaving it on the plug of your
2
motorcycle gas tank).
The helmet may become seriously damaged by
these chemical agents, without being readily
noticeable, thus compromising your protection.
Only use mild soap, warm water and a soft cloth to
clean and wipe both the helmet and visor.
7. Never apply paint, decals or adhesive tape onto
your shell or visor. These items may damage your
helmet, without being readily noticeable, thus
reducing your helmet's level of protection.
8. No helmet shall be modified from its original
specification as manufactured. Accessories
must be fitted in accordance with the helmet
manufacturer's instructions. Only accessories
evaluated during the type approval procedure of
the helmet can guarantee that the performance
of the modified protective helmet is covered by
the type approval. "
9. When wearing the helmet, your hearing will
be less acute, and both your field of vision and
head movements will be constrained. Be sure
to adapt your riding to account for this sensory
impairment.
10. Dry your helmet at room temperature.
Never expose it to a temperature above around
160°F/70°C, which could occur for example if
your helmet is left on the passenger seat or in
the boot of a car.
Always keep the helmet far from heat sources,
such as the bike's exhaust pipe or the top case.
11. For any question or comment regarding your
helmet, please contact the SHARK Company or
your nearest retailer.
WARNING! We do not guarantee the
capacity of this product to fully protect
its user against all possible shocks at either
high or low speed, or against all potentially
fatal injuries. The helmet user hereby
acknowledges and recognises the presence
of risks inherent in riding a motorcycle,
which are not strictly restricted to shocks,
regardless of their magnitude, at high or low
speed. By purchasing and using this product,
the user is expressly assuming and accepting,
willingly and knowingly, these risks and
moreover discharges the SHARK Company of
all liability, up to the maximum limit allowable
under the law, for any damage that may occur.