Cobra G100 Manuel Utilisateur Et Installation page 97

• The buzzer emits an acoustic signal (if enabled). Once the Driver
Card has been recognised, the LED switches off.
NOTE: It is also possible disarm the alarm system in the event of an
emergency by pressing the button on the Driver Card, without unlocking
the doors.
7.4 - Deactivating the ultrasonic volumentric sensor.
If you wish to arm the protection system with the windows left open or
when a passenger will be staying inside the passenger compartment, it
is possible to deactivate the volumetric sensor so that it will not generate
any alarms.
• Within 5 s after having turned off the ignition and from the door
opening, keep the button pressed down until you see the LED
give a long flash. If a hyperfrequency or anti-lifting sensor is
installed, it is possible to disarm it by pressing the button again
within 5 s after the LED has flashed. The LED will flash again to
confirm its deactivation.
• Arm the system by pressing the radiocontrol button: the sensors
are deactivated but all the other protections are active.The sensors
will be automatically reactivated the next time the ignition is turned
on.
7.5 - Driver Card Function.
The Driver Card is also used for the user recognition phase.
When the doors are unlocked by the vehicle's original radiocontrol the
system goes into a "pre - disarm" phase which lasts for 15 s, activated
by the opening of a door. When 15 s have elapsed after the door opened,
unless Driver Card recognition has occurred an alarm state is generated.
It is possible to disarm the system during the alarm phase using the
G300 USER AND FITTING INSTRUCTIONS
06DE2245D OK.pmd
GB
123
Driver Card key or by keying in the entire pin code from the LED panel.
Arming / disarming can also be executed by pressing the little key on
the Driver Card (see page 117 on www.cobra-at.com).
7.6 - Protection functions.
When the system is armed, opening the bonnet / boot / door or attempting
to start the vehicle generates an acoustic and visual alarm cycle that
lasts approximately 30 s. In products that include a volumetric sensor,
the alarm will be triggered off by intrusion into the passenger
compartment. At the cycle's end the system stays armed.
7.7 - Alarm record.
If any alarms have occurred during your absence, the direction lamps
and buzzer will emit their signals 5 times instead of once.
8 - HOW TO CONFIGURATE POSITIVE PERIMETRICAL INPUT.
Enable line 6 on the basic tables function following the instructions written
on the reverse side (see paragraph 14 on "How to programme the G300
system" on www.cobra-at.com)
09/09/2008, 10.07
123