Publicité
Les langues disponibles
Les langues disponibles
BERNINA CutWork Design
The cutting line in a BERNINA CutWork Design is split up and indicated in 4 different colours. The
colours refer to the 4 positions of the BERNINA CutWork Tool.
Cut 1
Cut 2
It is recommended to print out the design preview in the BERNINA CutWork Software.
IMPORTANT: BERNINA CutWork Designs must not be rotated again once positioned on the
machine!
Attaching the BERNINA CutWork Tool
Loosen the needle clamp screw to remove the embroidery or sewing needle. Insert the BERNINA
CutWork Tool into the opening of the needle clamp, flat side of needle shank to the back. Slide it up
fully to the stop and retighten the needle clamp screw.
IMPORTANT: Replace standard stitch plate with BERNINA CutWork stitch plate!
BERNINA CutWork Tool position
•
Depending on the machine model, the cutting
position is shown differently in the screen
(aurora - EC on PC program)
BERNINA 830
Cut 3
Cut 4
Ec on Pc
EN
•
Open BERNINA CutWork Design
•
The cutting direction will appear in the Color
Information Bar: Cut 1, Cut 2, Cut 3 or Cut 4
•
The displayed position (e.g. Cut 1) can be
adjusted by turning the wheel on the BERNINA
CutWork Tool
•
Start the machine
For bernette 340 Deco:
When cutting out, set the BERNINA CutWork
Tool to the next «Cut» position in each case at
«thread change». In order to be able to see the
preset position in the screen, press «X» to close
the «thread change» notice window.
The thread colours of combined patterns (cutting
and embroidery) are not displayed. Use the
«Print» button for colour information.
How to replace the needle
Loosen the small screw on the BERNINA Cut-
Work Tool only slightly, don't turn it out entirely.
Take care that the screw meets the flat area of
the needle. This guides/pushes the BERNINA
CutWork Needle into the correct cutting direction.
This is also to avoid that the cylindrical shank
of the BERNINA CutWork Needle is damaged.
If damaged, the needle might get stuck in the
BERNINA CutWork Tool.
Please note that only genuine BERNINA
CutWork needles can be used.
5
Publicité
