Boston Scientific SC-5250 Mode D'emploi page 40

Freelink™ Remote Control Handbook, 90930929-10, Rev A
Save and restore an area in a Program
To save any Area parameter changes so that they are the default parameters, you must
save the Program P . This will save all changes to any Area within that Program. You
cannot save the changes for each individual Area independently of changes for other Areas
in the same Program. See Save a Program on page 26.
If, after saving changes to a Stimulation Area in a Program, you decide that you want to
revert the Stimulation Area back to the way it was configured by your healthcare provider,
P
you can do so by restoring the Program . Restoring the Program will restore all of the
Stimulation Areas of that Program. See Restore a Program on page 28.
Page 40