Charger Status Display; Adjusting The Clipping Pressure - Heiniger XPLORER Traduction De La Notice Originale

6.4

Charger status display

The LEDs are shown as follows in these operating instructions:
1
1 LED switched off
2
2 LED lights up red
3 LED lights up green
3
Four charging statuses are displayed with the LEDs:
Power supply unit connected
The continuous green light on the lower LED signals that the power supply unit is
correctly plugged into the power socket. The charger is supplied with power and
is ready to operate.
Normal charging
The green light indicates that the battery is charged. The charging process is displayed different-
ly depending on the status:
Discharged battery,
0 % battery charge
Deep discharging
If the battery is deeply discharged the bottom LEDs lights up green. The char-
ger will attempt to charge the battery. If after a short while the voltage has not
increased, the display shows "Battery defective". If the voltage has increased,
normal charging starts.
Defective battery
If the battery cannot be charged or is defective, the top LED flashes red.
6.5

Adjusting the clipping pressure

Fig. 8
NOTE!
If the clipping pressure is too low, hair can gather between the clipping blades. This
X
results in a poor clipping quality. In this case, clean the clipping blades as described
in chapter 6.10.
Translation of the original instructions / Cattle and Horse Clipper
approx. 30 %
battery charge
Set the clipping pressure as follows before you start
clipping:
Turn the adjusting knob in the direction of the arrow
X
until you feel resistance.
Turn the knob another 1/4 turn in the direction of
X
the arrow.
After each new setting, check the cutting power on
X
the animal and only then continue turning.
If the clipping quality deteriorates, increase the
X
clipping pressure by turning the adjusting knob
another 1/4 turn in the direction of the arrow. If this
does not produce the desired result, the blades
must be replaced or sharpened.
approx. 75 %
battery charge
approx. 90 %
battery charge
13