Operation - solamagic S2 2500 Instructions De Montage Et D'utilisation

Operation

via wireless remote control
Switching
on/off:
Short-term
heating:
Heating level:
Memory-
function:
Timed
switch off:
Synchronisation: If multiple radiant heaters are controlled using the same hand-
11/2016
Brief pressing of the programmed wireless channel button on
the hand-held transmitter switches the connected radiant hea-
ter on or off.
Double-clicking the programmed wireless channel key swit-
ches the radiant heater on for 15 minutes and then automati-
cally switches it off again.
Extended pressing of the programmed key on the hand-held
transmitter switches the heat output up and down between
three levels (33, 66 and 100%).
Upon switching back on, a short press of the key recalls the last
heating level.
If a timed switch-off has been activated in the programming,
the radiant heater always switches off automatically after the
specified time. The radiant heater signals as follows after the
activating the set residual run time:
Signal duration 2s -
Signal duration 4s -
Signal duration 6s -
held transmitter button, faults in the wireless transmission
path can result in different states. For synchronisation, use
the function „Heating level" to initially set all radiant heaters
in switched-on state. Then switch off all receivers by a briefly
pressing the key. The „Heating level" function can now be used
to simultaneously set again all the actuated receivers.
28
30 minutes residual run time
60 minutes residual run time
90 minutes residual run time