solamagic S2 2500 Instructions De Montage Et D'utilisation page 20

ved for indoor and outdoor use. The connectors need to remain plugged in if
the device is used outdoors.
• If being used in wet rooms, observe the installation instructions, VDE 0100,
Part 701. Heaters must be installed in bathrooms such that the switch cannot
be touched by a person in the bath or under the shower.
• Never leave the heater unattended.
• Do not cover the heater when it is switched on or still hot; there is a risk of fire.
• The wireless receiver is equipped with an overtemperature protection which
will temporarily limit the heating function in the event of an overtemperature.
• This heater is not equipped with a room temperature control unit and must
not be used in small rooms that are inhabited by people who cannot leave the
room independently, unless constant supervision is ensured.
• To adjust the radiation direction, switch the heater off and allow to cool.
• Do not look directly at an operating IR halogen lamp for a long period and from
a short distance.
• IR halogen lamps are sensitive to direct skin contact (do not touch with bare
fingers). Grease or other contamination can be removed with an alcohol-so-
aked cloth.
• To maintain the service life of the IR halogen lamp, it must be protected against
vibrations, impacts and contaminants such as acids, ammonia, cement dust,
etc.
• The IR halogen lamp must be protected against mechanical loading. It must be
replaced if changes (dark spots, deformation) become apparent or the rated
life time is reached.
• Repair work (replacement of a defective power lead, a defective heating tube
or similar) must only be carried out by the customer service of the manufactu-
rer or an authorised dealer.
• Cleaning and maintenance work must only be carried out by adults with suffici-
ent expertise.
11/2016
20