Initial Operation; Remote Control - solamagic DS 02007 Instructions De Montage

Initial operation

Plug the plug into the socket.
For those models without a switch or remote control, heating starts
immediately upon plugging of the plug into the socket.

Remote control

The heater type DS 02010 is equipped with a remote control; initial programming is
necessary for initial operation.
LED assignment
Hand-held transmitter
Switching on/off:
Short-term heating:
Heating level:
Timed switch off:
Memory function:
02/2015
1 2 3
1 2 3
Brief pressing of the programmed radio channel
key on the hand-held transmitter switches the
infrared heater on or off.
Double-clicking on the programmed radio channel
key switches the infrared heater on for 15 minutes
and then automatically switches it off again.
Long pressing of the programmed key on the
hand-held transmitter switches the heat output up
and down between three levels (33, 66 and 100%).
The LEDs signal the selected heat levels.
If a timed switch-off has been activated in the
programming, the infrared heater always switches
off automatically after the specified time of 30 / 60 /
90 minutes. Every minute, LED 2 signals the
residual time by differentiated flashing. Each one
second flash duration indicates 15 minutes of
outstanding heating time.
Upon switching back on, a short press of the key
recalls the last heating level.
1
Key allocations:
Keys 1 – 4
Radio channel keys
3
2
4