Programming The Wireless Remote Control - solamagic S2 2500 Instructions De Montage Et D'utilisation

Programming the wireless remote control

Important: • Only those heaters should be connected to the mains that are
to undergo programming to a hand-held transmitter key. This
allows the programming of several receivers (multi-power).
Previously programmed devices can remain connected to the
mains.
• Use of other components with a wireless-signal interface
(e.g. wireless PC mouse and keyboard) may result in faulty
operation of the wireless receiver. Switch off all other wireless
components, particularly when programming.
• The wireless receiver is briefly disabled after command entry
using the hand-held transmitter.
Initial
programming: The heater to be programmed is connected to the mains. Brief
pressing of the desired key 1 to 4 on the hand-held transmitter
triggers wireless receiver programming (heating tube starts at
low level). Repeated pressing of the same key confirms the pro-
gramming (heating tube switches to top level).
If desired, time-out switching can be programmed by double-
clicking: If the programmed key is pressed briefly twice in suc-
cession, the heater will switch off in 30 minutes. The heating
tube activates for 2 seconds. Double-clicking again increases
the heating duration to 60 minutes (heating tube illuminates for
4 seconds). Double-clicking again increases the shut-down to
90 minutes (heating tube illuminates for 6 seconds). Double-cli-
cking once more switches the time control off. The programming
cycle for time-out switching begins again from the beginning.
Programming is ended by long pressing of the programmed key
of the hand-held transmitter. The heating tube confirms that pro-
gramming is completed by operating for two seconds.
25
11/2016