Switching Off And Disconnecting The Appliance; Defrosting - Bosch B21CT80SNS Notice D'utilisation Et De Montage

Chiller Drawer
The Chiller Drawer has a maximum load of 22 lb
(10 kg).
Pulling out and installing the Chiller Drawer
1. Pull out the Chiller Drawer.
2. Find the hooks at the left and right sides at the
drawer bottom (shown in the figure).
3. Hold the hook at two sides with a nose pliers and
push it up and out of the groove of sliding rail and
take out the hook at the other side with the same
method.
4. Take out the drawer.
Hook
Sliding rail
5. Install the drawer by putting the hook into the slots.
Switching off and
disconnecting the appliance
Switching off the appliance
Unplug the appliance or switch off the fuse.
Disconnecting the appliance
If the appliance is not used for an extended period of
time:
1. It is imperative that you disconnect the water
supply to the appliance for a few hours before
switching off the appliance.
2. Remove all food from the appliance.
3. Unplug the appliance.
4. Empty and clean the ice maker and the ice storage
box.
5. Clean the appliance interior (see "Cleaning the
appliance").

Defrosting

Freezer compartment
The fully automatic Nofrost system ensures that the
freezer compartment remains free of ice. Defrosting is
not required.
Refrigerator compartment
Defrosting takes place automatically.
The condensation runs through the drainage hole into
an evaporation pan at the rear of the appliance.
Chiller Drawer
en-us
21