Transport; Storage; Care And Maintenance; Maintenance Schedule - Kärcher BD 50/50 C Bp Classic Mode D'emploi

 Drain off the dirt water - regulate the
water quantity by pressing or bend-
ing.
 Rinse the waste water tank with
clear water.
Drain off clean water
 Unscrew the lock of the fresh water
reservoir.

Transport

DANGER
Risk of injury! When loading or unload-
ing the machine, it may only be operat-
ed on gradients up to the maximum
value (see "Technical Specifications").
Drive slowly.
CAUTION
Risk of personal injury or damage!
Mind the weight of the appliance during
transport.
 Press down and push the device
using the push handle.
 When transporting in vehicles, se-
cure the appliance according to the
guidelines from slipping and tipping
over.

Storage

CAUTION
Risk of personal injury or damage!
Consider the weight of the appliance
when storing it.
This appliance must only be stored in
interior rooms.

Care and maintenance

DANGER
Risk of injury! Set the programme se-
lector switch to "OFF" and pull the
mains plug of the charger prior to per-
forming any work on the appliance.
Remove the battery plug from ma-
chine.
 Drain and dispose of the dirt water
and the residual fresh water.

Maintenance schedule

After each operation
ATTENTION
Risk of damage. Do not sluice the ap-
pliance with water and do not use ag-
gressive detergents.
 Drain off dirt water.
 Rinse the waste water tank with
clear water.
 Clean the outside of the appliance
with a damp cloth which has been
soaked in mild detergent.
 Check the fluff filter, clean if re-
quired.
 Clean the vacuum lips and the wip-
ing lips, check for wear and replace
if required.
 Check the brush for wear and re-
place if required (see "Maintenance
tasks").
Monthly
 Check battery poles for oxidation,
brush off if necessary. Ensure that
the connection cable sits firmly.
 Clean the seals between waste wa-
ter tank and cover and check for
tightness, replace if required.
 Check the acid density of the cells if
the batteries are not maintenance-
free batteries.
Yearly
 Have the prescribed inspection car-
ried out by the customer service.

Maintenance Works

Replace or turn vacuum lips
1 Wear indicator
2 Vacuum lip
The vacuum lips must be replaced or
reversed if they are worn down to the
wear indicator.
7
-
EN
 Remove the vacuum bar.
 Unscrew the star grips.
 Remove the plastic parts.
 Remove the vacuum lips.
 Insert new or reversed vacuum lips.
 Insert the plastic parts.
 Screw in and tighten the star grips.
Replacing the disk brushes
 Push down the device holding the
push handle so that the cleaning
head is raised.
 Press the pedal for changing the
brushes downward beyond its re-
sistance.
 Pull the device towards the back so
that the disc brush becomes acces-
sible.
 Place a new disc brush on the floor
in front of the device.
 Drive the device with the raised
cleaning head over the new disc
brush and lower the cleaning head.
The brush locks into the drive.
Removing the waste water tank
 Drain off dirt water.
 Lift up the waste water tank and put
it aside.
9