Setting Up The Audio Setup Page; Audio Out; Digital Out - Marantz DV4001 Mode D'emploi

DVD Setup Menu

Setting up the AUDIO SETUP page

1 Press the SETUP button.
2 Select AUDIO SETUP PAGE using the cursor
buttons ( 2 / 3 ), then press the ENTER
button.
Use the cursor buttons ( 5 / ∞ ) to select the
3
desired item, then press the cursor ( 3 ) or
ENTER button.
AUDIO SETUP PAGE

AUDIO OUT

DIGITAL AUDIO
HDMI AUDIO OUT
CD UPSAMPLING
AUDIO DRC
Note
• Press 2 to go back to the previous menu item.
Press SETUP to exit the menu.
AUDIO OUT
• Default setting: STEREO
• STEREO – This option will downmix Dolby
Digital signals directly into analogue
stereo from L/R jacks.
• LT/RT – This option should be used only
if your DVD player is connected to a
Dolby Prologic decoder.
• VIRTUAL SURROUND – This option will
reproduce the surround channels virtually.
Note
• DTS is not supported.
• You can also select it using the SOUND MODE
buttons on the remote control.

DIGITAL OUT

• Default setting: ALL
Set the Digital output according to your
optional audio equipment connection.
• OFF – Turn off the digital output.
• ALL – If you have connected your DIGITAL
AUDIO OUT to a multi-channel decoder/
receiver.
• PCM ONLY – Only if your receiver is not
capable of decoding multi-channel audio.
Note
• If HDMI is activated, DIGITAL OUT is muted. HDMI
audio out is related to the "DIGITAL OUT" setting.
If set the "ALL" is set, HDMI Audio out is follows the
EDID. If set the "PCM" is set, HDMI Audio out is
always PCM.
• If set the "PCM" is set, DTS is muted.
• If you set to "ALL" with a non-DTS compatible
amplifi er, noise will be output when you play a DTS
disc.
6
35