Power Fist 8549768 Manuel D'utilisateur page 12

8549768
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Problem(s)
The jaws will not
open.
The stroke is too
short.
The riveter has
weak pulling
action.
Leaking air.
12
3/16 in. Air Hydraulic Riveter
Possible Cause(s)
The nosepiece is loose.
The jaws are dirty.
The rivet pin is not properly
inserted into the riveter.
The riveter is low on
hydraulic oil.
The rivet is the wrong size
Low air pressure.
Inadequately sized
compressor.
Damaged air compressor.
The riveter is low on
hydraulic oil.
There are poor hose
connections in the system.
Damaged O-ring.
Dirty air valve or air inlet.
Suggested Solution(s)
Tighten the nosepiece.
Remove and clean the jaws.
Fully insert the rivet pin.
Top up the hydraulic oil reservoir
and prime the riveter.
Use the proper rivet length.
Check the regulator to verify that
it is set to 90 PSI.
Upgrade to a suitable compressor
of adequate capability.
Have the compressor serviced by
a qualified service centre.
Top up the hydraulic oil reservoir
and prime the riveter.
Reconnect the air system using
thread sealant tape on the fittings.
Replace the O-ring.
Clean and lubricate with
pneumatic tool oil.
For technical questions call 1-800-665-8685
V4.1