Sirius SLT960 Instructions D'utilisation Et Avis De Montage page 12

WARNINGS
The appliance is not intended for use by
young children or infirm persons without
supervision. Young children should be su-
pervised to ensure they do not play with
the appliance.
The air sucked can't be conveyed throu-
gh or into a duct used to let out fumes
from appliances fed by energy other than
electric power (eg. centralized heating, ra-
diators, water-heaters, etc.).
To evacuate the air outlet, please comply
with the pertaining rules given by compe-
tent authorities.
Provide the room with an adequate aeration
when a cooker hood and appliances fed by
energy other than electric power (gas-, oil-,
or coal- stoves, etc.) are used simultaneou-
sly. The cooker hood, when evacuating the
sucked air, could generate a negative pres-
sure in the room- which can't exceed the li-
mit of 0.04 mbar, in order to avoid the suck
of exhausts deriving from the heat-source.
Therefore the room should be provided with
air-intakes to allow a costant flow of fresh air.
If the rating lable in the cooker-hood does
not show the symbol
built in class I° and it needs the earth con-
nection.
When performing the electrical connections
on the appliance, please make sure that the
current-tap is provided with earth connection
and that voltage values correspond to those
indicated on the label placed inside the ap-
pliance itself.
Before carrying out any cleaning or maintai-
ning operations, the appliance needs to be
removed from the electric grid.
If the appliance is not provided with a non-
separable flexible cable and plug, or with
another device ensuring omnipolar discon-
nections from the grid, with an opening di-
stance between the contacts of at least 3 mm,
then such disconnecting devices must be
supplied within the fixed installation.
, the appliance is
12
If the appliance is endowed with a supply cord
and a plug, the appliance has to be put in a
place where the plug can be reached easily.
The use of materials which can burst into
flames should be avoided in close proxi-
mity of the appliance. When frying, please
pay particular attention to fire risk due to
oil grease. Being highly inflammable, fried
oil is especially dangerous. Do not use un-
covered electric grills. In order to avoid
possible fire risk, all instructions for grea-
se-filter cleaning and for removing even-
tual grease deposits should be strictly fol-
lowed.
USES
PANELS OPENING
The grease filters cover panels are opened by
slightly pulling them , as shown in fig. 1.
Open the glass panels using both hands and
take them up to full opening.
CONTINUE TO TAKE THE GLASSES UP WHI-
LE OPENING THEM.
BEFORE INSTALLATION , IN ORDER TO AVOID
ANY POSSIBLE DAMAGE TO THE GLASSES ,
WE RECOMMEND TO REMOVE THEM BY UN-
SCREWING THE EIGHT SCREWS SHOWN IN
FIG.18. ELECTRICALLY DISCONNECT THE LED
BARS , BY USING THE SPECIFIC BIPOLAR AC-
TUATOR , AND REFIT THE GLASSES AND THE
ELECTRIC WIRING ONCE INSTALLATION IS
COMPLETED.
THE APPLIANCE CAN BE INSTALLED IN
BOTH BUILT-IN
VERSION.
For proper operation, we recommend to in-
stall the appliance at a maximum distance of
2000 - 2100 mm from the floor.
Before installing the appliance, check that all
the components are not damaged, otherwise
contact your retailer and do not carry out in-
stallation.
Use an air exhaust pipe , whose length does
not exceed 5 meters.
- Limit the number of elbows , since each
elbow reduces the appliance air capacity of
about 1 linear meter . (E.g.: if no. 2 x 90°
elbows are used , the piping length shall not
AND FREE-STANDING