Sirius SLT960 Instructions D'utilisation Et Avis De Montage page 15

In order to fit the air out-let in the hood shor-
ter side, you need to remove the steel plug
(fig.9), by unscrewing the four fixing screws,
and then connect the air out-let with its spe-
cific bracket, as shown in figure 14.
In order to fit the air out-let in the hood lon-
ger side, you need to open the hole found in
the centre of the hood longer side ( fig. 12 ) ,
then fit the air out-let flange with its specific
bracket, as shown in figure 15.
Bring the appliance close to the ceiling and
push the power cord and the motor cable
through the specific pass (fig.2).
Secure the hood to the ceiling , by tightening
the nuts supplied .
Perform the electric connection into the po-
wer supply metal box found inside the ap-
pliance and connect the remote motor cable
to its specific connector .
Refit the grease filter and close the glass pa-
nels.
Connect the air exhaust pipe to the hood air
out-let flange .
If you choose to fit the air out-let in the
hood shorter side, you can make the pipe fi-
xing operation easier by removing the cover
shown in fig. 16
The use of charcoal filters is not necessary
in this case
The false ceiling (plasterboard) shall be over
the larger side of the hood, fig. 13.
Provide a structure which is suitable to
bear the weight of the false ceiling, in or-
der it does not weigh on the hood.
WORKING
6 - channel radio control for cooker hood re-
mote (fig. 10).
Technical data:
Alkaline battery powered: 12v mod. 23A
Operating frequency: 433.92 Mhz
Combinations: 4096
Max. consumption: 25mA
Operating temperature: -20° : +55°C
- To light the cooker hood on or to
light it off press the button:
- To increase the speed up to the
fourth one press the button:
- To reduce the speed up to the
second one press the button:
- To go from a high speed back to
the first one press twice the button:
- To give power to the lights or to
shut them down press the button:
The "light" switch can turn the lights on and
off. after the first touch of the light switch the
lamps turn on at the maximum power.
- To set the timer up press the
button:
At first ignition, keep pressed the lighting
button for 5 seconds
The LED on the right side will start to flash
(every 5 seconds), the hood will work for 10
minutes at the selected speed and then it
lights automatically off.
If the client increases or reduces the speed
while the timer is on, this is automatically
stopped.
15