Cover And Cushion Components - Permobil ROHO Hibrid Select Mode D'emploi

Cover and Cushion Components

To remove the cover:
Unzip the cover. Make sure the inflation valve is inside the cover. Push the ISOFLO into the slot and inside the cover. Place the product, air cells
facing up, on a stable surface. Remove the cover.
To remove the cushion components:
1. Detach all quick disconnects
from the ISOFLO.
To install the cushion components:
1. If using the IT Air Pad, place
it into the cutout area of
the foam base. The tubing
should face the opening in
the foam base.
To install the cover:
1. Confirm that the cushion
components are installed
correctly and connected
to the ISOFLO.
ROHO Hybrid SELECT Operation Manual
2. Pull the tubing through the opening in the
foam base.
2. Place the Large Air Pad onto the foam base,
carefully matching the hook/loop strips. Make
sure the Large Air Pad is securely attached to the
foam base. Make sure there is NO GAP between
the Large Air Pad and the foam base.
IMPORTANT! The flange of the IT Air Pad (if
using) should lie under the flange of the Large Air
Pad.
The "flange" is indicated
by the dotted line.
2. Place the foam base on a
stable surface. Slide the
cover over the front of the
cushion, and make sure it
is snug.
Note: If used, hook fastener strips that were removed prior to washing should be replaced.
3. Remove the cushion components, releasing them
from the hook/loop fastener strips.
3. Insert the tubing through the opening in the foam
base.
4. Using the quick disconnects, attach each tube to the
ISOFLO.
When attaching the quick disconnects: The
tubes can be attached in any order.
5. Position the inflation valve tubing in the channel.
3. Pull the ISOFLO out through the front
slot in the cover.
Push the inflation valve through the
hole in the corner of the cover. Make
sure the tubing is in the channel.
6
4. Place the cover around the
rear corners of the foam base.
Close the zipper.
IMPORTANT! Check to
make sure the cover fits
correctly on the contours of the
cushion.