Setup - Permobil ROHO Hibrid Select Mode D'emploi

Setup

STOP HERE if using the Hybrid Select without the IT Air Pad. Refer to the "Offloading Option" in this manual before completing the
Setup instructions on this page.
Warnings - Before Use: Read all safety information and perform all steps below. Transfer to the cushion only after performing all steps
included in "Setup" (two pages). Make sure the cushion is properly sized to the individual.
SETUP - PART ONE: Remove the cover and unlock the ISOFLO.
1. Using a stable surface, such as a table, unzip and open the cover.
Turn the product over and make sure the quick disconnects are
securely connected to the ISOFLO.
Note: When attaching the quick disconnects: The tubes can be
attached in any order.
Inflation valve
SETUP - PART TWO: Perform atmospheric inflation.
IMPORTANT! Make sure there is NO WEIGHT on the air pads. If the individual is sitting on the cushion, transfer off.
1. Open the inflation valve.
Notes: To open, turn at least one full rotation.
The inflation valve will spin freely when open.
You can use the hand pump nozzle to open
the inflation valve.
Open
SETUP - PART THREE: Cover and place in the wheelchair.
1. Before closing the cover:
- Make sure the Large Air Pad
is positioned correctly, with
the hook and loop strips
aligned.
- Make sure the Large Air Pad
is securely attached to the
foam base.
- Make sure there is NO GAP
between the Large Air Pad
and the foam base.
ROHO Hybrid SELECT Operation Manual
Quick Disconnects
ISOFLO Memory Control
2. Inflate with the hand pump until all of the air cells feel firm.
Note: All air cells will inflate at the same time.
3. Remove the hand pump, and DO NOT close the inflation valve.
4. Allow air to escape from the inflation valve. Listen (or place a hand in front of the
inflation valve) to see if the airflow has stopped.
5. Close the inflation valve completely. The cushion is now inflated to atmospheric
pressure.
No gap!
2. Make sure the ISOFLO is unlocked. See the "ISOFLO Memory
Control" section.
Note: When the ISOFLO is unlocked, the air flows freely through
all of the air cells. You will not be able to inflate the cushion unless
the ISOFLO is unlocked.
Unlock
GREEN KNOB
2. Zip the cover closed (see
cover installation instructions).
3. Place the Hybrid Select on the
wheelchair (air cells facing up
and non-skid surface of the
cover facing down).
Note: Use the symbol on
the cover to help orient the
cushion.
Continue with the instructions on the next page.
4
Close