Pride Mobility Victory XL 130 Manuel De L'utilisateur page 31

To install the positioning belt (if required):
1. Remove the seat from your scooter.
2. Place the seat upside down so that you can see the
bottom of the seat base. See fi gure 21.
3. Use a wrench to remove the two rear bolts on the
outermost part of the seat frame.
4. Insert the bolt through the appropriate ends of the
positioning belt and then reinstall the bolts back
into the seat frame.
5. Tighten the bolts.
Metal tab style positioning belt
To adjust the positioning belt for operator comfort:
1. Insert the metal tab on the right side of the belt into
the plastic housing on the opposite strap until you
hear a "click." See fi gure 22.
2. Pull the strap on the right side of the belt until it is
secure, but not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic
housing.
MANDATORY! Make sure the positioning
belt is properly secured to the scooter
and is adjusted for operator comfort
before each use.
MANDATORY! Inspect the positioning
belt for loose parts or damage, including
tears, worn spots, bent hardware, or
damaged latch mechanisms, dirt or
debris, before each use of the scooter.
If you discover a problem, contact your
authorized Provider for maintenance
and repair.
Full-size Scooter Series
V. C O M F O R T A D J U S T M E N T S
Figure 21. Positioning Belt Bolts
Figure 22. Positioning Belt - Metal Tab Style
31