Pride Mobility Victory XL 130 Manuel De L'utilisateur page 35

V I I . B A S I C T R O U B L E S H O O T I N G
FAULT CONDITION
CODE
Batteries need charging
1
Low voltage; batteries need charge
2
immediately
Over voltage
3
Over current
4
Park brake fault
5
Throttle control lever not centered at
6
start-up
Throttle control lever broken or faulted
7
Motor fault
8
Other fault
9
Figure 26. Models with LCD Control Panel
What if my scooter does not move when I engage the throttle control lever?
 When the manual freewheel lever is pushed forward, the brakes are disengaged and all power to the motor/
transaxle assembly is cut.
 Push rearward on the manual freewheel lever, turn the scooter off , and then turn the scooter on to return to
normal scooter operation.
What if the main circuit breaker repeatedly trips?
 If the main circuit breaker trips repeatedly, see your authorized Provider for service.
 Charge the batteries more frequently. See III. "Batteries and Charging."
 If the problem continues, have both of your scooter's batteries load tested by your authorized Provider.
 You may also perform the load test yourself. Battery load testers are available at most automotive parts stores.
Follow the directions supplied with the load tester.
 See III. "Batteries and Charging" or the additional "Product Specifi cations Sheet" for information about your
scooter's battery type.
What if the battery condition meter dips way down and the motor surges or hesitates when I engage the
throttle control lever?
 Fully charge your scooter's batteries. See III. "Batteries and Charging."
 Have your authorized Provider load test each battery.
 See the previous troubleshooting question for load testing the batteries yourself.
If you experience any problems with your scooter that you are not able to solve, immediately contact your
authorized Provider for information, maintenance, and service.
Full-size Scooter Series
SOLUTION
Charge batteries as soon as possible.
Charge batteries as soon as possible.
Unplug charger and/or turn scooter off , then back
on.
Turn scooter off for a few minutes, then turn scooter
back on.
Remove the key from the key switch, then push
the manual freewheel lever to the drive (rearward)
position and restart your scooter.
Return the throttle control lever to center position,
turn scooter off , then back on.
Contact your authorized Provider.
Contact your authorized Provider.
Contact your authorized Provider.
ERROR
MESSAGE
N/A
Lo BAT
HI BAT
HI CUR
BRAKE
T POT
T POT
MOTOR
OTHER
35