Care And Maintenance - Pride Mobility Victory XL 130 Manuel De L'utilisateur

V I I I . C A R E A N D M A I N T E N A N C E
Your scooter requires a minimal amount of care and maintenance. If you do not feel confi dent in your ability to
perform the maintenance listed below, you may schedule inspection and maintenance at your authorized Provider.
The following areas require periodic inspection and/or care and maintenance
TIRE PRESSURE
 If equipped with pneumatic tires, always maintain the psi/bar/kPa air pressure rating indicated on each tire.
WARNING! It is important that the psi/bar/kPa air pressure rating indicated on each tire be
maintained in pneumatic tires at all times. Do not underinfl ate or overinfl ate your tires. Low
pressure may result in loss of control, and overinfl ated tires may burst. Failure to maintain the
psi/bar/kPa air pressure rating indicated on the tires at all times may result in tire and/or wheel
failure.
 Regularly inspect your scooter's tires for signs of damage or wear.
EXTERIOR SURFACES
Bumpers, tires, and trim can benefi t from an occasional application of a rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooter's vinyl seat or tire tread, as
this may cause them to become dangerously slippery.
CLEANING AND DISINFECTION
 Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your scooter. Avoid
using products that may scratch the surface of your scooter.
 If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for use on
your product before application.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or cleaning
agent before applying it to your product. Failure to comply may result in skin irritation or
premature deterioration of upholstery and/or scooter fi nishes.
BATTERY TERMINAL CONNECTIONS
 Make certain that the terminal connections remain tight and uncorroded.
 The batteries must sit fl at in the battery wells.
 The battery terminals should face away from the seat post.
WIRING HARNESSES
 Regularly check all wiring connections.
 Regularly check all wiring insulation, including the charger power cord, for wear or damage.
 Have your authorized Provider repair or replace any damaged connector, connection, or insulation that you
fi nd before using your scooter again.
PROHIBITED! Even though the scooter has passed the necessary testing requirements for
ingress of liquids, you should keep electrical connections away from sources of dampness,
including direct exposure to water or bodily fl uids and incontinence. Check electrical components
frequently for signs of corrosion and replace as necessary.
WARNING! Do not pull on electrical harnesses directly to detach them from the scooter. Always
grasp the connector itself when disconnecting the harness to prevent wire damage.
36
.
Full-size Scooter Series