Pride Mobility Victory XL 130 Manuel De L'utilisateur page 33

V I . D I S A S S E M B LY A N D A S S E M B LY
FRAME SEPARATION
To separate frame:
1. Arrange the front wheel(s) in a straight
forward-facing position.
2. Lower the tiller.
NOTE: The pivoting tiller is equipped with a
mechanism that will lock the front wheels in
place when the tiller is completely lowered
and secured.
3. Grasp and lift up on the frame release
lever. See fi gure 24.
4. Lift the front section up until the frame
hooks of the front section separate from
the rear section.
5. Slowly separate the two sections.
ASSEMBLY
To assemble your scooter:
1. Position the front and rear sections of your scooter as shown in fi gure 24.
2. Use the frame release lever to lift the front section as you align the frame hooks of the front section with the
lower frame tube of the rear section.
3. Once the frame hooks are over the lower frame tube, lower the front section and pivot the rear section
simultaneously. This will engage the frame lockup automatically.
4. Raise the tiller.
5. Connect the front-to-rear cable.
6. Reinstall the battery spacers if applicable. See fi gure 16.
7. Reinstall the batteries to the battery wells.
8. Connect both battery harnesses. See fi gure 14.
9. Secure the battery tie-down strap.
10. Reinstall the battery shroud.
11. Reinstall the seat and rotate it into place.
WARNING! After assembly, make absolutely certain the tiller lock knob is in the unlocked
position before riding your Scooter.
Full-size Scooter Series
IDENTIFICATION KEY
1.
2.
Figure 24. Frame Release Lever
FRAME HOOK
LOWER FRAME TUBE
33