Pride Mobility Victory XL 130 Manuel De L'utilisateur page 16

REAR COMPONENTS
The manual freewheel lever, anti-tip wheels (if equipped), motor/transaxle assembly, and optional safety fl ag
brackets are located on your scooter as shown. See fi gure 7. The main circuit breaker (reset button) and batteries
(not shown) are also located on the rear component section of your scooter.
WARNING! Before placing your scooter into or taking it out of freewheel mode, remove the key
from the key switch. Never sit on a scooter when it is in freewheel mode. Never put a scooter in
freewheel mode on any incline.
Figure 7. Rear Components
Manual Freewheel Lever
Whenever you need or want to push your scooter for short distances, you can put it in freewheel mode.
1. Remove the key from the key switch.
2. Push forward on the manual freewheel lever to disable the drive system and the brake system. This will enable
you to push the scooter.
3. Pull back on the manual freewheel lever to reengage the drive and the brake systems and take your scooter
out of freewheel mode.
WARNING! When your scooter is in freewheel mode, the braking system is disengaged.
Disengage the drive motors only on a level surface.

Ensure the key is removed from the key switch.

Stand to the side of the scooter to engage or disengage freewheel mode. Never sit on a

scooter to do this.
After you have fi nished pushing your scooter, always return it to the drive mode to lock the

brakes.
NOTE: If the scooter is placed in freewheel mode (manual freewheel lever forward) while the key is in the
"on" position, the scooter will not run until the manual freewheel lever is pushed backward and the key is
turned to the "off " position, then back to the "on" position.
Motor/Transaxle Assembly
The motor/transaxle assembly is an electromechanical unit that converts electrical energy from your scooter's
batteries into the controlled mechanical energy that drives the scooter's wheels.
16
I I . Y O U R S C O O T E R
IDENTIFICATION KEY
1. MANUAL FREEWHEEL LEVER
2. MOTOR/TRANSAXLE ASSEMBLY
3. ANTI-TIP WHEELS (if equipped)
4. SAFETY FLAG BRACKETS
Full-size Scooter Series