Auto-Restart; Air Flow Direction Adjustment; Water Drainage - Midea MPPB-14CRN7 Manuel D'utilisation

Operation

AUTO-RESTART

f the unit breaks off unexpectedly due to the power cut,it will restart
with the previous function setting automatically when the power
resumes.
WAIT 3 MINUTES BEFORE RESUMING OPERATION
After the unit has stopped, it can not be restarted operation in the first 3
minutes. This is to protect the unit. Operation will automatically start after
3 minutes.

AIR FLOW DIRECTION ADJUSTMENT

The louver can be adjusted automatically. Adjust the air flow direction
automatically:
-When the Power is ON, the louver opens fully.
-Press the SWING button on the panel or remote controller to initiate the
Auto swing feature. The louver willl swing up and down automatically.
-Please do not adjust the louver manually.
POWER MANAGEMENT feature
When the ambient temperature is lower (Cooling mode) or higher (Heating
mode) than the setting temperature for a period of time, the unit will be
automatically operate power management feature. The compressor and
fan motor stop and the power management indicator light illuminates.
When the ambient temperature is higher (Cooling mode) or lower (Heating
mode) than the setting temperature, the unit will be automatically quit the
power management feature. The power management indicator light turns
dark and the compressor and (or) fan motor run.

Water drainage

-During dehumidifying modes,
remove the upper drain plug
from the back of the unit,
install the drain connector(5/8"
universal female mender) with
3/4" hose(locally purchased).
For the models without drain
connector, just attach the drain
hose to the hole. Place the open
end of the hose directly over the
drain area in your basement floor.
NOTE: During cooling mode, please
reinstall the upper drain plug to the
unit securely to reach the maximum
performance and avoid leakage.
-During heating pump mode, remove
the lower drain plug from the back
of the unit, install the drain connector
(5/8" universal female mender) with
3/4" hose(locally purchased). For
the models without drain connector,
just attach the drain hose to the
hole. Place the open end of the
Hose adaptor directly over the
drain area in your basement floor.
NOTE: Make sure the hose is
secure so there are no leaks.
14
EN
Remove the
upper drain plug
Continuous
drain hose
√
Remove the
lower drain plug
Continuous
drain hose
drain hose
adaptor
√