Lubrication - LGB 24772 Mode D'emploi

Programming by means of Pages (Universal-Handy 55015)
All CVs up to CV 1024 can be changed with programming by means of pages. The
process can be compared to programming by means of CVs, but it uses the CVs 1 to 4
in place of CV 5 for the value. Pages are areas in which 4 addresses can be summa-
rized. CVs 1 to 4 correspond then to the 4 addresses that are summarized on the page.
The numbers to be entered can be generated with the following equations:
(CV - 1 ) / 4 = Page Whole number result is Page
(decimal x 4) + 1 = Data CV
If for example CV 322 is to be programmed at 200, the following calculation will result:
(322 -1) / 4 = 80,25 Page 80; CV6 = 80
0,25 x 4 + 1 = 2
In order to program that the „page" 80 is first programmed in CV 6 and the value 200
is immediately programmed in CV 2.
Value in CV 2
Maintenance

Lubrication

The axle bearings and the side rod bearings should be lubricated occasionally with a
small amount of Märklin-Oil (7149).
Replacing the light bulbs (E130023)
Carefully lift the lens out of the lantern housing. Then use a pair of tweezers to pull
the light bulb out of the bulb holder. Now insert a new light bulb. Finally, put the
lantern back together.
Replacing the smoke generator (Fig. 3 & 4)
• Pull the cover off the smoke stack.
• Use a pair of needle nose pliers or a pair of tweezers to pull the old smoke unit out
of the smoke stack.
• Cut the wires.
• Connect the wires to the new smoke unit. To do this, strip a little insulations from
the ends of the wires, twist the wires, and finally insulate the wire connections.
• Push the new smoke unit into the smoke stack.
• Put the model back together.
13