Accessories - Scheppach dms 1100 Traduction Du Manuel D'origine

Possible causes are:
window or door gaps.
the connection cable.
of the wall socket.
Such defective electrical connection cables must not be
used as the insulation damage makes them extremely haz-
ardous.
Check electrical connection cables regularly for damage.
Make sure the cable is disconnected from the mains when
checking.
Electrical connection cables must comply with the regula-
tions applicable in your country.
Single-phase motor
fied on the motor's rating plate.
cross-section of 1.5 mm
mm2.
16 A slow-acting fuse.
Only a qualified electrician is permitted to connect the ma-
chine and complete repairs on its electrical equipment.
In the event of enquiries please specify the following da-
ta:
If a motor has to be returned, it must always be dispatched
with the complete driving unit and switch.
Problem
Motor doesn't start
Drilled holes become
larger than the drill bit
Work piece flatters
while working
Tool rest or tailstock
cannot be clamped
12 english
2 , and beyond 25 m at least 2.5
Trouble shooting
Possible Cause
b) Defective switch, condenser
c) Defective extension cord
Headstock and tailstock are not parallel.
a) Working piece becomes loose
while working
b) Work piece is not properly centered
Setting the eccentric clamping
elimination of any malfunctions must only be undertak-
en after turning off the motor.
immediately upon completion of any repair or mainte-
nance work.
when changing tools.
by unscrewing it, cleaned and then sprayed with a dry
lubricant. Grease the threaded spindle.
tool holder and adjust if necessary. In addition, tighten
the hex nut under the bracket.
Article
-
Help
a) Check fuse
b) Have an electrician inspect unit
necessary
Set up headstock according to the tailstock
tip. Insert carrier into the drilling spindle for
this and position the tailstock with tip up to a
a) Follow the instructions in the operating
manual
b) Follow the instructions in the operating
manual
c) Select a lower rotational speed
Maintenance

Accessories

Art. No.