Scheppach dms 1100 Traduction Du Manuel D'origine page 12

ing processed due to centrifugal force.
can be hazardous.
ports are not correctly adjusted or if turning tools are
blunt. Sharp turning tools which are free of defects are
necessary for professional turning.
the work piece is rotating. Wear personal protective gear
such as a hair net and tight fitting work clothes.
sonal protective gear such as safety goggles and a dust
mask.
to injuries caused by electricity.
maining hazards which are not yet evident may still be
present.
in the entire operating manual.
Assembly (figure 2 – 5)
Your scheppach drilling machine is subassembled for techni-
cal reasons involved with packaging.
Fig. 2 Slightly screw the frame feet in pairs with the up-
per frame angle (each 3 neck bolts M8 x 12 with washer
and nut), put on sole plates.
Fig. 3 Screw the bottom chassis with the frame feet also
only hand-tight (each 2 neck bolts M8 x 12 with washer
and nut).
Fig. 4 Place the drilling machine onto the frame and
firmly screw with the 8 Allen screws ;8 x 35, with spring
washer and nut.
Fig. 5 Insert the switch from inside into the frame foot
and screw on with the Phillips head screw M4 with
washer and nut.
Start-up
Observe the safety notes in the operating instructions before
operating the machine.
Remove the tensioning spindle or the chuck from the spindle
in addition to any step-up tools before first operating the ma-
chine!
Reversing switch, Fig. 6
Your turning machine is equipped witha reversing switch.
The motor is always switched on and off using the operat-
ing switch. I = green; 0 = red.
The reversing switch is merely a selector for the direction
of rotation. You can change the direction of rotation from
anticlockwise to clockwise
The speed setting can only be done when engine is running.
For safety reasons, it is not possible to switch directly from
anticlockwise to clockwise when the motor is running.
When the reversing switch is in 0-position it switches the
motor off, which must be switched back on using the green
switch.
10 english
-
-
-
-
as you require.
Speed adjustment Fig. 7
The speed can only be adjusted during work.
The correct number of revolutions is visible on the speed
diagram located on the headstock. The speed diagram is
intended for medium-hard dry woods.
The appropriate speed is based on various factors such
as:
Successful wood turning does not result from high speeds,
but rather, from correct use of the machine.
Guidelines for speed adjustment
Low speeds for:
Speed adjustment
the left.
tion indicated by the arrow. The binder can be moved
freely to the left or right.
belt to the desired level. The belt must lie exactly in the
grooves of the belt disc.
by applying light pressure to the lever (2). Tighten the
binder (1) and return to its vertical position.
NOTE: Extremely high belt-tension causes rapid wear of the
belt.
the viewing-window.
lect a speed at least one level lower.
Driver, Fig. 1.2, A
The driver is used exclusively for work between both cent-
ers.
Face plate, figure 1.1
The face plate is used with flat larger tools.
Change of the clamping tools
with the hexagonal spanner.
Headstock, figure 9
on the drilling bed in order to attach the tool rest from
the left onto the tailstock.
diameters.
-
-