Electrical Connection - Scheppach dms 1100 Traduction Du Manuel D'origine

Tailstock
stock can be moved over the entire length of the bed and
can be secured at any distance from the headstock.
binder, turn the sleeve approx. 20 mm outward and
clamp.
stock center into the sunken point in the center of the
workpiece.
two centers and can be rotated freely.
Tailstock center replacement, Fig. 1.1, 4
tip can be removed.
Tool holder, Fig. 9, 10
tools and at the same time serves as a support for the
hand.
The height of the tool holder can be adjusted once the
binder has been loosened. To turn further, pull in the
direction indicated by the arrow.
workpiece. Check the adjustment in addition to rotating
the workpiece by hand.
piece.
Check the adjustment once again by rotating the work-
piece by hand.
console can be moved along the entire length of the bed
and in the direction perpendicular to the workpiece. Fur-
thermore, the holder console can be tilted over approx.
45º to either side.
and place up against the surface to be worked. Depend-
ing on the wood turning tool, place the tool holder up to
6 mm underneath the axis of the workpiece.
extension is to be used (Fig. 11).
that larger discs can be processed.
Use of wood turning tools, Fig. 11
Examples of how to use the tools when working with the
most frequent forms. Once the machine has been plugged
in, it is ready to be used. Observe the operating instruc-
Operations
A perfect and sharp wood turner tool is a precondition for pro-
fessional wood-turning.
Selection of materials
out imperfections such as fissures against the grain, a
marred surface, or knots. Faulty wood tends to split and
becomes a risk for both the operator and the machine.
workpiece can explode as a result of developing cen-
trifugal force, turning such wood demands careful gluing
- without weak points.
Note:
working exclusively with solid material.
Preparation of the materials
- into a square form beforehand.
its natural state as well. Saw out the rough form with a
band saw. An octagonal form is recommended for the
material so that vibrations are reduced.
Centering of the workpiece (Fig. 12)
Centering the prepared workpiece is an important opera-
tion to be performed before placing it into the machine.
Centering consists of measuring the middle point of the
workpiece and marking it with a center punch.
Make a depression of 1.5 to 2 mm in the middle point.
If the workpiece has not been centered exactly, strong vi-
brations will develop as a result of the imbalance. It is
possible that the workpiece could be hurled outward as a
result.
NOTE: Exact centering of the workpiece produces smooth
concentricity.
While working with the turner
speeds.
- ing operation is complete once the basic form of the
workpiece as well as an even concentricity have been
achieved) can the speed be raised.
with the hand wheel. This operation only should be per-
formed when the motor has been turned off.
The tailstock center should rest firmly in the wood.
Marking of the workpiece
Sometimes the workpiece has to be taken out before it has
been completed. It is advantageous to mark the workpiece
and the driver with a pencil first.
When placing the workpiece back in the machine, match
the marks on the workpiece and the driver.
Specialized literature
Specialized shops offer appropriate specialized literature
about wood turning. They can be a great help for beginners
in their work as well as a source of ideas for experts.

Electrical connection

The installed electric motor is completely wired ready for
operation.
The customer's connection to the power supply system,
and any extension cables that may be used, must conform
with local regulations.
Important remark:
- The motor is automatically switched off in the event of an
overload. The motor can be switched on again after a cool-
ing down period that can vary.
Defective electrical connection cables
Electrical connection cables often suffer insulation dam-
age.
-
english 11