Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Replacing the vibration dampers
CAUTION: Always switch off the engine and pull the plug
cap off the spark plug (see "Replacing the spark
plug"). Always wear protective gloves!
CAUTION: Start the chain saw only after having assembled
it completely and inspected!
Always replace all five vibration dampers.
5
1
E
-
The vibration damper (E/1) is installed next to the identification
plate.
-
The vibration damper (E/2) is installed underneath the guide
bar support. The chain catch (a) must be removed.
-
The vibration damper (E/5) is installed under the mounting
arm of the tubular handle.
Replacing vibration dampers 1 - 4
4
G
-
Put the saw chain on its side and carefully remove the
protective cover (G/4) by means of the universal wrench.
I
-
Carefully demount the vibration damper by means of the
universal wrench.
-
The vibration damper is mounted in the reverse order.
30
2
a
b
F
3
-
The vibration damper (F/3) is installed underneath the oil
tank cap.
-
The vibration damper (F/4) is installed underneath the pre-
filter. The cover (a) and pre-filter (b) must be removed.
H
-
Use the offset screw driver to loosen the screw inside.
Replacing vibration damper 5
a
J
-
Demount the tubular handle (a) (5 screws).
-
Use the socket wrench (accessories, not delivered with the
chain saw) to demount the vibration damper carefully.
-
The new vibration damper is mounted in the reverse order.
4
a
Publicité
Chapitres
Table des Matières
