Cleaning The Brake Band And Sprocket Interior; Replacing The Saw Chain; Replacing The Suction Head - Dolmar PS-33 Instructions D'emploi

Cleaning the brake band and sprocket interior

A
5
- Remove the sprocket guard (A/1) (See "PUTTING INTO
OPERATION" figs. A and B).
- Turn the chain tightener screw (A/2) to the left (counter-
clockwise) until you feel resistance.
- Remove the chain (A/3) and guide bar (A/4).
- Clean the interior with a brush, in particular the brake-band
area (A/5).
NOTE:
Make sure that no residue or contaminants remain in the oil
guide groove (A/6) and the chain tightener (A/7).
- For replacing the guide bar, chain, and sprocket see
"PUTTING INTO OPERATION".

Replacing the saw chain

CAUTION:
Use only chains and guide bars designed for this saw (see
the Extract from the spare-parts list)!
1 2
B
Check the sprocket (B/1) before mounting a new chain.
The sprocket is located underneath the clutch drum (B/2).
CAUTION:
Worn out sprockets (C) may damage the new chain and must
therefore be replaced.
Do not attempt to replace the sprocket yourself. Sprocket
replacement requires special training and tools and must be
done at a DOLMAR service centre.
18
6
2
3
7
4
1
C
CAUTION: Before doing any work on the guide bar or
chain, always switch off the engine and pull
the plug cap off the spark plug (see "Replacing
the spark plug"). Always wear protective gloves!
CAUTION: Start the chain saw only after having assem-
bled it completely and inspected.
NOTE:
The chain brake is a very important safety device and like
any other component subject to normal wear and tear.
Regular inspection and maintenance are important for your
own safety and must be done by a DOLMAR service centre.

Replacing the suction head

D
The felt filter (D/1) of the suction head can become clogged.
It is recommended to replace the suction head once every
three months in order to ensure unimpeded fuel flow to the
carburetor.
To remove the suction head for replacement, pull it out
through the tank filler neck using a piece of wire bent at one
end to form a hook.
STOP
SERVICE
1