Replacing The Saw Chain; Replacing The Fuel Filter; Cleaning The Air Filter - Dolmar PS-3410 TH Manuel D'emploi Et De Sécurité

Replacing the saw chain

CAUTION: Use only chains and guide bars designed for
this saw (see the Extract from the spare-parts list)!
Check the sprocket (7) before mounting a new chain.
Remove the sprocket guard (see "PUTTING INTO OPERATI-
ON" A-H)
CAUTION: Worn out sprockets (8) may damage the new chain
and must therefore be replaced.
Replacing the clutch drum and sprocket
Release the chain brake if necessary.
Lever off the circlip (11) using the universal wrench and remove
the washer (10).
Pull off the clutch drum together with the sprocket (9) and fit a
new clutch drum and sprocket in reverse order.

Replacing the fuel filter

The felt filter (12) of the fuel filter can become clogged.
It is recommended to replace the fuel filter once every
three months in order to ensure unimpeded fuel flow to the
carburetor.
To remove the fuel filter for replacement, pull it out through
the tank filler neck using a piece of wire bent at one end to
form a hook.

Cleaning the air filter

Unscrew screw (14) and remove the filter cover (13).
IMPORTANT: Cover the intake opening with a clean cloth in
order to prevent dirt particles from falling into the carburetor.
Remove the air filter.
CAUTION: To prevent injury to the eyes, do NOT blow out
dirt particles! Do not use fuel to clean the air filter.
Clean the air filter with a soft brush.
If the filter is very dirty, clean it in lukewarm water with dish-
washing detergent.
Let the air filter dry completely.
If the filter is very dirty, clean it frequently (several times a day),
because only a clean air filter provides full engine power.
CAUTION:
Replace damaged air filters immediately.
Pieces of cloth or large dirt particles can destroy the en-
gine!
32
7
8
9
10
11
12
C
D
13
14
E