Emerson EUCLID CF500AP00 Mode D'emploi page 6

Masquer les pouces Voir aussi pour EUCLID CF500AP00:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Ceiling Fan Assembly
3.3
Remove one #8-32 x 3/8" round head screw with
lockwasher from the motor hub and retain for later use.
Loosen the other two #8-32 x 3/8" round head screw with
lockwasher on the motor hub for the installation of the switch
housing adapter.
Place the motor hub connectors through the center hole of
the switch housing adapter.
Place the switch housing adapter onto the motor hub,
aligning the three screw holes (Figure 3).
Rotate the switch housing adapter key hole slots clockwise
to engage both loosened screws (Figure 3).
Reinstall the previous removed #8-32 x 3/8" round head
screw with lockwasher.
Secure the switch housing to the motor hub by tightening the
three switch housing screws.
3.4
Tuck all the wires and wire connectors into the switch
housing adapter.
Remove the three #8-32 x 5/16" flat head screws from the
switch housing adapter and retain for the installation of the
switch housing cover.
Align the three screw holes of the switch housing cover
onto the switch housing adapter (Figure 4).
Reinstall the previous removed #8-32 x 5/16" flat head
screws.
Secure the switch housing cover to the switch housing
adapter by tightening the three switch housing screws
(Figure 4).
A spare #8-32 x 5/16" flat head screw supplied in parts bag,
if needed.
The finial may be removed for use with an Emerson light kit.
(Continued)
ROTATE ADAPTER
CLOCKWISE
Figure 3
#8-32 x 5/16" FLAT
HEAD SCREWS (3)
Figure 4
6
#8-32 x 3/8"
ROUND HEAD SCREW
WITH LOCKWASHER
SWITCH HOUSING
ADAPTER
SWITCH HOUSING COVER
FINIAL
SWITCH HOUSING ADAPTER
U.L. Model No.: CF500

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Euclid cf500sbs00Euclid cf500torb00

Table des Matières