Declaration Of Conformity - Alecto WS-1150 Mode D'emploi

RESET/SYSTEM ERROR
If you've lost the overview of the settings or
the WS-1150 appears to be malfunctioning,
we recommend you to reset the indoor and
outdoor units.
1. Remove the batteries from the indoor and
outdoor unit.
2. Wait for at least 10 seconds and then
replace the batteries.
3. Follow the registration procedure (see
paragraph 'Installation').
After several seconds the indoor and outdoor
unit will have recognised each other and you
can start using the WS-1150 again.
If you still have no connection or sound,
please contact the customer service of
Alecto: www.alecto.nl
ENVIRONMENT
At the end of its lifespan, this
product should not be discarded as
normal domestic waste, but is must
be taken to a collection point for the
recycling of electric and electronic
equipment.
Don't throw away exhausted batteries, take
them to your local depot for small chemical
waste.
SPECIFICATIES
Indoor unit:
indoor temperature measurement range:
0°C ~ +50°C (32°F ~ +122°F)
resolution: 1°C (1.8°F)
Humidity range:
20% ~ 95% relative humidity
resolution: 1%
accuracy: 10%
Power supply:
2x 1.5V battery, size AAA, alkaline
Outdoor unit:
outdoor temperature measurement range:
-50°C ~ +70°C(-58°F ~ 158°F)
resolution: 1°C (1.8°F)
Power supply:
2x 1.5V battery, size AAA, alkaline
Transmission frequency:
433,88MHz
Power:
-13,6 dBm
Range:
up to 50 meters

DECLARATION OF CONFORMITY

Hereby, Hesdo declares that the radio equip-
ment type Alecto WS-1150 is in compliance
with directive 2014/53/EU. The full text of the
EU declaration of conformity is available at
the following internet address: http://DOC.
hesdo.com/WS-1150-DOC.pdf
32