Battery Replacement - Alecto WS-1150 Mode D'emploi

Memory reset:
It's possible to delete the maximum and
minimum values.
1. press and hold the "MEM" button for
2 seconds until you hear a beep tone.
The maximum and minimum registrations
are now deleted.
Outdoor temperature alert:
See Temperature Alert Setup in chapter
Installation to set the alert limit.
activating/deactivating the alarm:
1. press the "ALERT" button to activate
the alarm (
2. press the " ALERT" button again to de-
activate the alarm (the
pears).
When the alarm is activated and the upper
or lower temperature limit is exceeded, an
alert signal will be emitted every 5 seconds
while the outdoor temperature display
starts flashing. This alarm signal is re-
peated each minute until the temperature is
within the limits again.
It's also possible to deactivate this alert.
appears in the display).
icon disap-

BATTERY REPLACEMENT

Indoor unit:
After replacing the batteries of the indoor unit,
all memories and settings will be deleted.
Outdoor unit:
After replacing the batteries of the outdoor
unit, you'll need to re-register it to the indoor
unit.
To do this, follow the instructions of chapter
'Installation'.
31