General Operating Instructions
Before operating the centrifuge, be sure that the power switch is in the "on" position. To begin a run, simply
close the lid of the centrifuge. No other controls are required. To stop the rotation, press the stop button on
the front of the unit. This will release the lid lock and the rotor will slow gradually to a complete stop.
Caution: Do not attempt to open the lid or remove samples until the unit has come to a complete stop.
After the rotor has stopped, the lid may be opened by grabbing it with the thumb and fingers on the back and
then lifting the lid back on the hinge.
Safe operation of the centrifuge requires that the rotor be loaded in a balanced fashion. Failure to load the
rotor properly presents a hazardous condition and may damage the centrifuge. Individual tubes, strip tubes
and/or adaptors must always be loaded symmetrically to ensure proper balance. Never run the centrifuge
with only one strip or tube in place.
Maintenance
Before using any cleaning or decontamination methods except those recommended by the
manufacturer, check with the manufacturer that the proposed method will not damage the
equipment. To clean the centrifuge: use a damp cloth and a mild, noncorrosive detergent
(pH<8). After cleaning, ensure all parts are dried thoroughly before attempting to operate
the unit. Do not immerse the centrifuge in liquid or pour liquids over it.
Questions and Service:
Should you have a question about the centrifuge or require service for the unit, please
contact your VWR International representative. Do not send in a unit for service without first
calling to obtain a repair authorization number and a decontamination form. Should the
centrifuge require service, be sure to decontaminate it and enclose the decontamination form.
The unit should be properly packed to avoid damage. Any damage resulting from improper
packaging shall be the responsibility of the user
6