ResMed Quattro Air Manuel D'utilisation page 14

Daily/After each use:

Disassemble the mask components according to the
disassembly instructions.

Thoroughly clean the separated mask components (excluding
headgear), by gently rubbing in warm (approximately 30°C)
water using mild soap.

To optimise the mask seal, facial oils should be removed from
the cushion after use.

Use a soft bristle brush to clean the vent.

Inspect each component and, if required, repeat washing until
visually clean.

Rinse all components well with drinking quality water and allow
to air dry out of direct sunlight.

When all components are dry, reassemble according to the
reassembly instructions.
Weekly:

Handwash the headgear.
Reprocessing the mask between patients
This mask should be reprocessed when used between patients.
Cleaning, disinfection and sterilization instructions are available from
the ResMed website, www.resmed.com/masks/sterilization. If you
do not have internet access, please contact your ResMed
representative.
6