ResMed Quattro Air Manuel D'utilisation page 13

Reassembly
Refer to the reassembly illustrations in this guide. A diagram
showing the names of parts can be found in the Mask Components
diagram near the beginning of this guide.
Reassembly steps
1. Press the frame onto the rest of the mask, ensuring it clicks into
place at the top and at both bottom corners.
2. Attach the top headgear straps to the frame by looping through
each of the upper headgear hooks. Ensure that the ResMed logo
on the headgear is facing outward and right side up.
3. Attach the elbow to the air tubing. Attach the elbow and air
tubing to the mask by pressing the side buttons and pushing the
elbow into the mask. Pull on the elbow to check that it sits
securely in the mask.
Cleaning your mask in your home
Your mask and headgear should only be handwashed by gently
rubbing in warm (approximately 30°C) water using mild soap. All
components should be rinsed well with drinking quality water and
allowed to air dry out of direct sunlight.
WARNING
Always follow cleaning instructions and use mild soap. Some
cleaning products may damage the mask, its parts and their
function, or leave harmful residual vapours that could be inhaled
if not rinsed thoroughly.
CAUTION
If any visible deterioration of a system component is apparent
(cracking, discoloration, tears etc.), the component should be
discarded and replaced.
English
5