Technical Data - ATIKA ADH 254 A Notice Originale

F ault
Machine is stalled
machining.
Workpiece is jammed during •
thicknessing.
Surface unsatisfactory.
Machined surface too rough.
Machined surface is shaky.
Workpiece advance is slow during
thicknessing.

Technical data

Model
Typ
Year of constructions
Motor rating P
1
Mains voltage
Mains frequency
Mains fuse
Idle speed (cutting blades)
Feed rate for thicknessing
Max. workpiece width
Workpiece height for thicknessing
Depth of cut for planing
Depth of cut for thicknessing
Cutting blade dimensions (length x width x thickness)
Table dimensions Planing
Thicknessing
Table height with stand
Weight
Diameter of the shavings exhauster connector
Possible cause
• Dull cutting bla
during
des
• Feed is too great
• Motor protecting s
only)
Exces sive depth of cut
• Dull cutting blades
• Cutting blades block
• Erratic feeding
• Too much moisture in the workpiece
• Workpiece was machined against the growth
direction
•
Too much material cut in a single pass
• Thicknessing adjusting lever not in its to
position
•
Resin on the thicknessing table plate
•
S luggish transport rollers
witch has tripped (230 V
ed by shavings
p
MBY10
1600 W (S1)
230 V~
21
Remedy
• Replace or s
harpen the blades.
• Continue working with slower rat
• Switch motor back on after cooling
("Motor protection", p. 16)
•
Reduce depth of cut and m
in multiple passes.
•
Replace or sharpen the blades.
• Remove shavings.
• Feed the workpiece with c
and reduced speed.
• Dry the workpiece.
• Machine the workpi
ece in opposite direction.
•
M achine the workpiece in multiple passes.
• Put the thicknessing adjusting lever to its to
F2.
position
•
Clean the tab le plate and apply a thin film of
sliding wax.
•
Repair the tra nsport rollers.
ADH 254 A
MBY10 (400V)
see last page
1800 W (S1)
50 Hz
1 0 A iner t
6700 rpm
8 m / min
254 mm
5 - 160 mm
0 - 3 mm
0 - 2 mm
258 x 20 x 2,5 mm
1050 x 260 mm
480 x 254 mm
890 mm
ap prox. 82 k g
75 mm
e of feed.
achine workpiece
onstant pressure
p
400 V3~