Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Technical data
Model designation
1
2
Mains voltage
Mains frequency
Rated current
Saw blade speed
Mains fuse
Saw blade ∅ maximum
Saw blade ∅ minimum
Saw blade location hole
Cutting speed (at maximum saw blade ∅)
Cutting height at 90° (for maximum saw blade ∅)
Cutting height at 45° (for maximum saw blade ∅)
Bevel cut adjustment (swivelling range)
Table size
Table height
Maximum cutting length for 10 mm workpiece thickness
Weight
Exhaust outlet guard ∅
Exhaust outlet ∅
Commercial, small dust collectors or industrial vacuum cleaners are used for vacuuming.
You must not start up the machine until you have read these operating instructions, observed all the
information given and assembled the machine as described.
Keep the instructions in a safe place for future use.
Before reading the operating instructions, fold out the pages at the start and end.
The motor is equipped with an electronic control, which keeps the cutting speed constant at each speed stage even when
loaded. Idle running, especially in low revolutions, can cause noise at gear which the operator may consider as unusual and
untypical for saws. This noise is absolutely normal and does not alt all affect the function.
A further advantage is the electronic motor protection. The motor is immediately cut-off in case of overloading or if the saw blade
The motor continues to run.
Contents
70 mm workpiece thickness
80 mm workpiece thickness
AZS
1900 W S 6-40%
1350 W S 6-40%
230 V~
50 Hz
9,5 A
1800 to 4200 min
10 A inert
250 mm
245 mm
30 mm
23,5 to 55
approx. 0 - 83 mm continuously variable
approx. 59 mm
-2° - 47°
765 x 580 mm
360 mm
321 mm
262 mm
234 mm
ca. 35 kg
30 mm
30 mm
12
13
13
13
13
13
14
15
16
16
electronically adjustable
-1
/
(depending on saw blade speed)
m
s
17
18
19
19
19
19
37
38
14
Publicité
Chapitres
Table des Matières
