Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Do not operate machine before having read the
operating instructions, understood all the notes
and assembly the machine as described here.
Keep the instructions in a safe place for future use.
Contents
machine
EC Declaration of Conformity
according to EC directive 2006/42/EC
We,
59227 Ahlen - Germany
herewith declare under our sole responsibility that the product
Surface planing and thicknessing machine
Type MB Y 10 / model ADH 254 A
Serial number: 00001 - 05000
is conform with the above mentioned EC directive as well as with
the provisions of the guidelines below:
2004/108/EC and 2006/95/EC
Following harmonized standards have been applied:
EN 861:2007+A1; EN 60204-1:2006+A1; EN 55014-1:2006;
EN 55014-2:1997+A1; EN 61000-3-2:2006; EN 61000-3-11:2000
EC type examination carried out by:
TÜV Rheinland LGA Products GmbH
Certificat-no.: BM 50176726 0001
Keeping of technical documents at:
ATIKA GmbH & Co. KG - Technical department
Schinkelstr. 97 - 59227 Ahlen - Germany
Ahlen, 24.01.2011
A. Pollmeier, management
Extent of delivery
• Surface planing and thicknessing machine ADH 254 A
• Shavings exhauster hood
• Shavings exhauster connector
• 1 push stick
• Blade shaft guard
• Guide plate
12
• Stand
12
• Installation tools
12
• Fasteners
12/13
• Operating manual
13
13
After unpacking, check the contents of the box
13
That it is complete
15
Check for possible transport damage
15
16
Report any damage or missing items to your dealer, supplier or
the manufacturer immediately. Complaints made at a later date
18
will not be acknowledged.
18
19
Characteristics noise values
19
19
EN ISO 3744
20
Machine used as surface planer and thicknesser with standard
20
cutting blades.
21
No-load
Load
Planing
Load
Thicknessing
The factor of measurement uncertainty is 2 dB.
The values given are emission values and must therefore not
simultaneously represent safe workplace values too. Although there is
a relationship between emission and immersion levels, it can be
reliably deduced whether additional precautionary measures are
necessary or not. Factors, which can influence the immersion level
currently existing at the workplace include the duration of the effects,
the special type of the workroom, other noise sources, etc. e.g. the
number of machines and other adjacent processes. The permissible
workplace values can also vary from country to country. This
information should however enable an improved assessment of the
danger and risk to be carried out.
Symbols machine
Carefully read
operator's manual
and the safety in-
structions before
starting the machine
and observe the
instructions when
operating.
12
Noise power level
Sound pressure level
at the workplace
L
= 109,5 dB(A)
L
WA
L
= 112,3 dB(A)
L
WA
L
= 111,3 dB(A)
L
WA
Before starting any
repair,
maintenance or
cleaning work,
always switch off
the motor and
remove the plug
from the socket.
= 93,9 dB(A)
pA
= 99,3 dB(A)
pA
= 97,9 dB(A)
pA
Publicité
Chapitres
Table des Matières
