On/Off Switch; D Ust / Chip Exhaustion; Working With The Surface Planing And Thicknessing - ATIKA ADH 254 A Notice Originale

On/Off switch

D1
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired or
replaced immediately by the customer service.
Switching on
Press the green button ( I ) on the switch.
If there is a power cut, the machine switches off
automatically. Push the green ( I ) button to start the
machine again.
Switching off
Press the red button. ( 0 )
EMERGENCY-STOP button
In an emergency case, the surface planing and
thicknessing machine can be cut off by pressing the
EMERGENCY-STOP button (21).
Motor protection (230 V only)
The motor is equipped with a safety switch and switches
off automatically when overloaded.
It can be switched back on following a cooling off phase
(5 – 10 min).
Press the
1. red button ( 0 ).
2. the small button next to the button (20)
3. the green button ( I ) to start
Machine with 4 00 V 3~
Ensure that the rotating
direction of the blade shaft
matches the rotating
direction indicated on the
machine.
R otating direction
Y ou can change the direction by
placing a screw-driver in the slot
provided in the plug collar, and
adjust the correct direction by
moving to the left or right applying
slight pressure.
D ust / chip exhaustion
The wood dust generated during operation impedes the
necessary view and is harmful to health to some degree.
Ther efore, always connect the shavings bag (19) to th
shavings exhauster connector (16).
Empty the shavings bag on a regular b
C6 - C7
asis.
The motor will only start if the extractor
properly attached and thus releases the safety switch.
Working with the surface planing and
thicknessing machine
Before starting to work consider the following safety
advices to keep the risk of injuries as small as
possible.
W orkplace tidied?
Is the surface plan
installed?
Are all fastening screws tightened?
Are the blades securely fastened on t
whether the pushstick is to hand
You may not start to operate th
read these operating instructions, observed all the
instructions given and installed the machine as described!
Also, note the following important points:
Make sure that the non-used area of the bla
covered by the blade shaft guard.
Place yourself outside of the area of danger.
Place your hands flat on the workpiece with fing
Never remove loose splinters, chips, or similar by hand.
Connect the shavings bag.
Make sure that the feed r
from wood shavings and dust.
Do only machine workpieces the dimensions of which are
within the specifications for this machine (see "Technical
data").
Do not guide back the workpiece over the open-running
blade shaft.
Adjust the smallest cutting depth after your work is finished.
Observe all safety instructions in any case.
Surface planing
The objective of surfac
(planing), e.g. to smooth the edge of a board.
For this the workpiece is placed onto the feed table plate and is
machined on its underside. Feed direction is from right to left.
Preparations:
Pull the mains plug before performing
settings.
Installing the dust extractor
1. Lo en the locking wheel (24) on the os
turn the latter anticlockwisely to move the thicknessing table
plate to its lowest
2. Slide the shavings exhauster hood (27
plate. Slide two fixing brackets in the grooves of the table
e
E4 - E5
plate.
3. Make sure that
are secured.
16
ing and thicknessing machine securely
he blade shaft?
e machine until you
ollers and cutting tools are
e planing is to smooth a rough surface
crank handle (25) and
E2 - E3
position.
) under the feed table
the shavings exhauster hose and the bag
hood (27) is
have
de shaft is
ers closed.
free