mspa Alpine B-091 Manuel De L'utilisateur page 18

DRAINAGE, CLEANING & STROAGE
1.Spa Drainage
1. Turn off all the buttons (heater, filter and bubble) on the control panel unit.
2. Connect the drain valve adapter to a garden hose and point the other end of the
garden hose to a suitable draining area (Fig.1.1)
3. Remove the drain valve cap from the outside of the spa tub and attach the drain valve
adapter with the garden hose to the drain valve (Fig 1.2)
4. From the inside of the spa tub, open the drain valve cap, water will start following out
through the garden hose (Fig 1.3)
5. When the water stops draining, lift the spa tub wall from the opposite the drain, leading
any remaining water to the drain and empty the spa water completely. (Fig 1.4)
6. Press Bubble button to dry out any water in the piping system. Operate the
bubbling function for at 15 minutes to blow out all the remaining water. (Fig 1.5)
7. When the water stops draining, use a clean towel to wipe up any remaining water and
moisture on the spa tub and spa control panel. (Fig. 1.6)
1.6 1.5
Spa Tub Cleaning
If dirt is visible in the water or water becomes cloudy and proper water chemistry does not clear it up, change the water and clean the
spa tub.
While spa water is empty, remove the cartridge from the inside of the spa tub wall, clean and /or replace the filter cartridge. Use a sponge
and mild soap solution to wipe away any soil or stains on the inside of the spa wall. Rinse thoroughly before refilling with clean water.
IMPROTANT: Do not use steel wool, hard brushes or abrasive cleaners.
15
1 0 4
F
1.4
18
1.1
garden hose
1.2
17
1.3