Control Panel Operation; Temperature Button - mspa Alpine B-091 Manuel De L'utilisateur

CONTROL PANEL OPERATION

7
6
5
ON/OFF Button:
ON/OFF
Bubble Button:
The light of Bubble button displays green when activated.
Water Filter Button:
is activated. FILTER light will be off when temperature reaches pre-set level.
NOTE: Filtration cannot be turned off when Heating is activated.
Heater Button:
heat the spa water until the water temperature reaches the pre-set temperature. After the current water temperature
drops 2°C(3.6°F) below the set temperature, the heating system will restart automatically. When the HEATER button
is red, the heating system is activated. When the HEATER button is green, the heating system is at rest as the
filtration system is inactivated or the water is at the set temperature.

Temperature Button:

press Temperature Button once, and then shows CURRENT water temperature after 1 second.
NOTE: the default temperature is 100°F (38°C).
NOTE: Temperature adjustment ranges from 68°F(20°C) to 104°F(40°C).
Temperature Adjustment Buttons:
LED starts to flash, then you can set your desired temperature by pressing Increase or Decrease buttons. After
desired temperature is set, you can press TEMPERATURE button again, or wait for 10 seconds to see the current
water temperature.
Celsius/Fahrenheit Toggle button:
ºC
ºF
system's default is Celsius.
1 0 4
F
To active the control panel.
To active the bubbling massage function, which has a 20-minutes auto off for 10-mintues feature.
Active the filter pump. The light of the Filter Button displays green when the filtration system
Use this button to active the HEATING and FILTRATION function at the same time. The heater will
To display the water temperature. The control panel displays the SET temperature when
To adjust the temperature. Press EMPERATURE Button for 3 seconds,
The temperature can be displayed in either Celsius or Fahrenheit. The
1
2
3
4
15
1. ON/OFF Button
2. Bubble Button
3. Water Filter Button
4. Heater Button
5. UP & DOWN Button
6. Temperature Button
7. Celsius/Fahrenheit Toggle Button