mspa Alpine B-091 Manuel De L'utilisateur page 10

Additional requirements for indoor installation
Verify the supporting floor can support the filled weight of spa with maximum number of occupants. Check with a qualified contractor
or structural engineer to verify the requirement.
Make sure the floor is water resistant and provides non-slip surface. Do not install the spa on a carpet of any other material that could
damaged by the moisture.
Humidity is a naturally side effect of indoor spa installation. The room shall be properly ventilated to allow moisture to escape. Install
a ventilating system to prevent excess condensation moisture in the room.
Additional requirements for outdoor installation
Make sure to set up the spa on a firm, level and smooth surface that is strong enough to support the full weight of the filled spa and
maximum occupants.
Do not set up the spa on grass or dirt, as this increases the amount of debris entering the spa, and damage the spa floor.
Do not leave the spa tub exposed to direct sun light for extend period of time.
It is the possible to install and leave the spa outside at a temperature not lower than 4°C(39°F) and the water inside the circulation
system, pump, pipe are not frozen. Put a Heat Preservation Mat (*Optional) or the Electric Heating Mat (*Optional) in between the
spa bottom and the ground to prevent heat loss from the bottom of the spa and to provide better heat retention.
GFCI Testing
Risk of electric shock: This product is provided with a GFCI located at the end of the power cord. The GFCI plug must tested before
each use. Do not use the spa if the GFCI plug does not function properly. Disconnect the power cord until the fault has been
identified and corrected. Contact a licensed electrician to correct the fault. There are no serviceable parts in side the GFCI plug.
Opening the GFCI plug will void the warranty.
1. Plug the machine into the mains.
2. Press the RESET button on the GFCI. The indicator turns red.
3. Press the TEST button on the GFCI. The GFCI indicator should shut off. If the GFCI indicator does not turn off, the GFCI is faulty.
Do not use the spa. Contact a qualified electrician to correct the fault.
4. Press the RESET button on the GFCI again. The indicator should turn red. If yes, the spa is ready for use.
1.
! WARNING
2. 3.
RESET
TEST
RESET
10
4.
RESET
TEST
TEST
RESET
TEST
Indicator area